HT3CS27   (new Bigger Drill size) Maximize

HT3CS-27 Commercial Trumpet (new Bigger Drill size)


 I play on is the new HornTrader custom signature mouthpiece by Mark Curry. The HT 3CS 28.Some guys want a slightly larger hole.  This is the same commercial mouthpiece that I use only with the 27 hole 

HornTrader Custom Signature Mouthpiece The HT3CS-27 .

I am selling these pieces for $110 ( SH&I) Basically it is a high compression shallow 3C Trumpet Mouthpiece It is a slightly shallower Mt Vernon 3C copy with his #1 Back-bore and a 28 hole. My HT 3CS 28 is a rim that was copied from a Mt Vernon 3C that belonged to Arturo Sandoval Then the Cup was made a tad shallower (.017) but also a bit more room on the sides near the bottom of the cup The bite is soft like a worn Mt V 3C The contour is more straight to the shallower cup The drill is a 28 The Back bore has a 28 hole but is a straight taper #1 reamer. Medium tight with brilliance. About .017 shallower than a Mt Vernon 3C cup We've opened up the 2nd cup which should make it a little more free-blowing. And have added a slightly sharper shoulder going into the throat, making it a little more angular instead of a smooth radius. The X-28 Backbore has a 28 hole but is a straight taper #1 reamer. Medium tight with brilliance. Length 3.5" Weight 3.2 oz. Backbore exit diameter .333" Outside shank diameter .383" (gives a gap similar to a Reeves #5 sleeve) Can cut new ones for sleeves (add $25) Extra Sleeves are $25 ID .666" at 30 thou from the top of mouthpiece Bite radius .069" OD 1.07" Undercut angle 15.5 degrees main cup shortened by 17 thou, 2nd cup slightly wider, more angular. 70 thou/inch reamer,     1 size larger throat "27"

Contact Steve

For all your questions or for some expert advise. Consultations, shop visits, and lessons by appointment.

Phone (619) 401-2828

Contact Steve


visa mastercard paypal
Credit Card Services